Is that not the vacuum line for the carbon canister (probably removed). Been a while since I have been up close and personal in that area!
Type: Posts; User: sean737
Is that not the vacuum line for the carbon canister (probably removed). Been a while since I have been up close and personal in that area!
Cat not running hot enough or knackered, same as for stylusman I would say.
You need to establish what the week link in the chain is. If you are feeling confident guesstimate the max power the turbo will make. Either way pick a power and then there is a formula to...
I would have spent a little more money and bought a properly modded car:)
No problem
are you sure you wired the plug correctly?
I am near Gatwick. If you want you can come to me. I would be willing to put your AFM in my car to see if it works.
I had one fail but it was a...
They are only a few hundred quid!
I have no idea but the link suggests it varies with the year of z32 though this seems odd. It is no big deal to make a spacer as the dimentions do not have to be axact as there is qite a bit of...
You could make some from some bar of the correct diameter and drill a small hole in each end once cut to length. Then at one end use stock retaining clip and at other a bit of wire through both and...
Excellent. That solves the mystery! I have actually assembled and installed it as it is. As the bolt is tight in the knuckle it is held quite well. I would not want to use it for handbrake turns...
Ok. I got all the parts in bits from a fellow sxoc member. Unfortunately it would appear that there is a mismatch. When I built up the handbrake mechanism it all went together fine except for one...
Is that a custom made sump of your own design for the 200sx or is it a custom sump from some specialist?
Quite a lot of carbon build up. Perhaps some oil burning due to worn rings or valve guides. The strip down will tell you more. Maybe just running very rich.
By the way, I am not an expert. I...
Have not looked at doing it yet. Changing my rear set up first and see how that helps. It should be possible to remove it and then tap and sleave the hole thus blocking the ports. Will post back...
Not sure if I can be removed without destroying the BMC. I have a couple of spares so will give it a go.
The plan is to remove it and fit an adjustable valve in the rear circuit.
Depends on what I have eaten!
The question is:
Do I need to eat them?
I'lleat my pants if it turns out not to be the CAS.
abslolutly fine. Pedel a bit heavier and take-up slightly more abrubt but after five minutes you will be used to it.
From some of the descriptions sounds like ecu fuel cut.
I know a good guy in the Gatwick area if anybody interested. Sibot (can't find his no but he is on the net). I have had various problems with mine. Last time found a leek in the condenser. He...
I would always use a specialist as they properly vacuum drain the system and then refill with the correct amount of lubricant. That way you know it is right rather than just topping up the system. ...
Fantastic! I new it was bollocks but not what day of the year it is!
That's a lot of work for an April fool! Good one though.
? Can I have some of what you are on!
I have never found a 200sx that I can't get the pedal down to the floor on. They feel rock hard without the servo assistance but with it if you push hard enough it will go to the stop. Generally it...