Search:

you also have SumpScuffers who are in derby somewhere. those lads know their old nissans and are bloody good at fabrication work.

shame the top tube of the doors bars are so high up.

new cams = new rockers.

id say you will be fine with the rubbish bolt at the top as long the back plate is stuck on with sealant.

I tend to just weld a bit of 1" box section between the mounts.

jack on the rear subframe mounts or towing eye. then on the front tie down points on the radiator support panel.

worst case you can just slosh some fuel tank sealer around inside you s13 tank. probably have to take it off the car to do it though which is a ball ache.

I had a cometec and it leaked but I put it down to the fact id not skimmed the block. TBH I would not be worried about raised compression as modern fuel is much better that old 1990's stuff.

the bmw boxes tend to have rubbish ratios which don't really work with R200 diff ratios, ive seen people stick 350z diffs in to help combat this.

I was under the impression the cd09 hung down low...

that skills loop guy is up in the midlands. he gets some decent reviews, helps dig a lot of the pooley park trails.

Desa or here or conceptua are probably the cheapest for genuine gasket sets.
if your gaskets aint that old you could get away with reusing some of them

E bikes do seem to be real good fun but they aint half expensive.

most the guys round here seem to rate the Michelin wild E enduro tyres for E-bikes in the winter and the regular wild enduro's for...

if your oil light goes out you have oil pressure. you could take the oil filler cap off and see if you have oil sloshing around inside when its running.

Moog ones are decent quality.

the gen 2 have the cutouts in the rear lower cups where you can see the threaded part of the damper unit.

the irish lads seem to just get a few men and roll them onto their sides, then stand a wheel and tyre up so that it sits where the door windows would be.

goggle image search something like 'Team...

or just pop the spark plugs out and see what colour they are.

a lad local to me painted his car with graffiti spray paint, flatted it back and polished it, it looks really good and I didn't know it wasn't a proper paintjob till he said.

personally I would...

has the engine ever been rebuilt?

s14 kouki/zenki and S15 are the same underneath, but you are better just fabricating replacement parts.
steve at SR autobodies sells replacement inner and outer sills which would speed up the...

you could take the round black plastic cover off the CAS and check the trigger wheel isnt corroded etc..

just swap the sump and the strainer if its damaged. be careful of the O-ring on the strainer, if its old or damaged fit a new one.

try not to jack the car up in the middle of the front radiator...

I drove one a couple of months back but sadly not with too much anger but it did feel like it would be a total hoot on the twisty bits. it has a track day mode you activate by pressing a button by...

strange that it hasn't knackered the squish pads.

get the car proper hot before you take it to be tested.