Black Diamond/Tarox Discs & DS2500 Pads
Type: Posts; User: gunnerDAR
Black Diamond/Tarox Discs & DS2500 Pads
Was the heater core.Had it repaired and has occured again.Thanks for the replies :-)
Have had a coolant leak from my car for a few weeks dropping onto my downpipe.Not leaking badly but I need to resolve the issue prior to selling the car.Was hoping somebody may have an idea where its...
Thanks for all the input.Booked in at an AC specialist for a heater matrix replacement :)
I just had the heater on today on low to see what would happen and the leak was very slow and drops down on to the downpipe.I did have the aircon on the other day and the passenger footwell got...
Yes it is,have found out that its likely to be the heater core leaking or failed.Can anyone confirm that please?
Have found the location of the leak,is coming from one of the silver covered pipes on the bulkhead and leaking down on to the downpipe.The liquid is red so is coolant which I dont understand?
Hi,have just noticed a monumental water leak under my s14a.The passenger footwell is soaked with fluid as well.I have seen posts on other car forums mentioning this.I cant find any posts on SXOC with...
Yes,checked the cable and has some free play so isnt casing the problem.Did have it set correctly and then went to use the car later and the problem started over.I think its probably a vac leak or a...
Hi,hope somebody can help.Have been having issues with the tickover on my S14a for the past week or two.Couldnt get the idle to sit at 850 rpm so I obtained another IACV and installed with a new...
Got my actuator arm back on and all is back to normal thankfully.I also thought my turbo had packed in so extremely relieved and very grateful for all the advice received.Really good to have SXOC...
Thanks a lot for the info,was concerned id damage the actuator if I pulled on the connecting pipe.Cheers
Whilst driving home last night my actuator arm on the turbo decided to ping off leaving me basically in 'limp mode'-no boost etc.Is it possible to reattach the arm in situ as it doesn't quite reach...
Possibly copies,bought similar from a UK seller a while back.There were no markings on the injectors whatsoever.Had to open a case against the seller to get my money returned.As its from Australia...
Had the alignment done,ride height was fine.Handling is now sorted.Used the settings for the arms found on here and all has worked out well.Thanks again to everyone for the advice :-)
Thanks to everyone for all the advice and information.Will report back on the outcome.
Any suggestions on where else I could bet it aligned
/setup properly?-I'm in Gloucester so fairly restricted on where I can take it.
Am taking it to Chris Mullins.They use Hunter equipment and did an alignment for me a while back.Will ask them to set the ride height and set the car to the settings I've found on the forums.Will be...
Had the camber,toe and traction arms fitted at the same time so will be able to adjust accordingly.I'm aware that there should be 200mm on preload.The car is sitting 2.5 cm from the top of the arch...
Have just had some Hsd Monopros fitted to my 14a.I'm not overly technically minded but the rear of the car is really light-even pulling off from junctions the car has next to no traction.The steering...
Hi,do you have these in stock for an s14a please?
Thanks mate
I'm trying to find somewhere local that could paint my bootlid,spats,bumpers.Is there anyone local to Gloucester who does good work?
Hi,im looking for a modified APEX bracket that runs from the cat to the gearbox.How do I order one please?I have a 3 " downpipe.
In need of one of these brackets also?