Been searching like an idiot but can't find a definitive answer.
Has anyone actually tried to cut out the hole for the speedsensor and putting the gear on the shaft of an s15 gearbox?
Don't want...
Type: Posts; User: Mec
Been searching like an idiot but can't find a definitive answer.
Has anyone actually tried to cut out the hole for the speedsensor and putting the gear on the shaft of an s15 gearbox?
Don't want...
Got a link Sean?
Still waiting on a price with delevery to belgium so i can paypal some money over to you.
Are the mounting bushings for the godspeed arb (front) available separatly, mine are totally gone.
Taking the startermotor off is a piece of piss. two bolts, one power cable and one plug and it drops out at the bottom.
Most likely the brushes are stuck or worn down.
Simply take the endcap off...
Thx, was planning on doing that but was hoping to get the sizes before hand, so i could take it off and replace them immidiatly but thx anyway.
If anyone has the partnr for the startmotor itself i...
Nobody ?
Is there anyone that has the partnr for the starter motor brushes, dont have acces to fast anymore.
Nope it is the right one. if you push the bolt further in it will slot into the hole since there is a recess on the bolt. Have the same ones on mine.
Depending on wich direction you put the washer,...
CRC has a specialised spray for mafs, 05110
Get a set of apex. They fit perfectly and tighten up the front end nicely.
No unfortunatly not, i only tried the rc5+, wich is a very nice pad too.
I just get a bit more feel with the pagids.
Tried a lot of pads,
Greenstuff : crap , desintegrates
Redstuff : crap , desintegrates
Yellowstuff: a litlle les crap
TRW: Crap desintegrates
K-sport street: crap , wooden feel, not really...
K-sport ...
Filling the oil filter can help too
Has anyone tried to remove the backpiece from the front speaker pods on an s14.
Trying to get a little more midbass in front and was wondering if removing the rear half of the pods in the doors...
Monroe has a kit too
78127
I also found what appears to be the restrictor in the vct oil feed looked like it was hammered in with a screwdriver.
I did go through this with a small drill too without enlarging it to...
If you are willing to chuck some money at it why not go for twinscroll.
I have driven a subaru 2.0l engine (i know i know) with a gt3076 full twinscroll and the response was unreal.
Just over 2.2k...
When i took my engine apart i noticed a lot of instant gasket in the hole that feeds the vct sprocket. Right between the head and block. And this was on an unopened engine from the factory.
Also the...
Can you give me your paypal adress so i can send the money over for parts, please.
Can someone with a silent high power do me a favor and measure the inner diameter of the rear silencer, or actually the inner size of the bung that is welded in there.
Thanks, Patrick.
I see that you have refurbed the calipers. There is your problem. You have probably used new seals or at least taken them out to clean the calipers. What happens is that the seals need to set again. ...
Put washer on top of the threads before you screw it on.
Can you pm me a price for a set of front wings for an s14a and a driverside sidelight with shipping to belguim please.
Greetz, Patrick.