Are you sure it's shorten enough?
Sounds like it's still tightening on the thread?
Type: Posts; User: acs
Are you sure it's shorten enough?
Sounds like it's still tightening on the thread?
And if you do get ARP head studs the one above the water pump needs to be shortened or multiple washers otherwise it torques on the thread and not the head.
If that doesn't work and you want to go hardcore you could try
http://www.compbrake.com/product/nissan-200sx-brake-bias-servo-replacement-pedal-box-kit-hydraulic-dual-cylinder-kit-b/
I have one...
Would love to but there is nobody over here who can. So then do you just send the lot away to get it checked and ringed at the same time?
Million dollar question of what though?
Not looking for huge power but want to have long term reliability and the ability to stay out on track for a decent length of time.
The next stage is either to get the block ringed but I will have...
Yup ARP head studs and discovered that the stud above the water pump doesn't tighten on the head but the thread that was irritating. Blown 2 Cometic since discovering that. Generally lasts half a...
Cheers it's looking like that is the best option.
Thanks
Adrian
I have a nightmare with a cometic after my head and bloke have been decked. Keeps blowing in the same place into the water ways on the drivers side of number 1 and leakage between cylinders 1,2 and...
First page of google hits would hint that it's not one to use.
Never heard of Athena before are they any good?
Thanks
Adrian
Does anyone know where you can get a non Nissan and non Cometic head gasket from these days? FRSport say they have them until you try and order them and then they're out of stock.
Should of said...
Cheers I just saw the gap and thought that's surely not right.
Yup bmc stopper is on the cards I had one on the old master cylinder hopefully I will be able to edit it up a bit.
Thanks
A
It least makes me feel better that it isn't just my car was built after the factory party!
Yup that's the one.
Other side is all welded up nicely like I'd expect drivers side gap!
Not yet meant to and got distracted I will take one tomorrow.
thanks
A
Took my master cylinder off today because it was leaking and decided to replace with one of these
...
Superb thank you just needed to make sure before I solder and loom up.
Thanks
A
Thanks for that. I'm presuming the red 12v is a switched feed from the ignition?
I'm fairly sure it spliced into the 12v feed that comes from goes to the front passenger side relay box? Sound...
Ok so I got a little keen removing wires I didn't think I needed from the engine bay.
Does anyone know the extra colours on the red cable going to the resistor injector pack. I believe it's red...
I have just been through a lot of pain with ARP headbolts besides the deep socket that I had to buy a set off Amazon and get it machined down to get it to fit.
The thing to be aware of is the stud...
Thanks just what I need mine have given up
Right all is good I have spoken to Greg.
I know Greg reputation is very good and I don't know anyone close and it's a flight for me get there which is why I'm trying to find out what is...
He's was definitely moving Protuner towers I dropped my car off at the new place which was under going a huge kit out and I was delayed two weeks in dropping my car off.
I don't actually care when...
Before I call the Police
And I Shit you not this is my next option
Has anyone heard from Greg Gush? (Protuner)
Five weeks ago I dropped off my s13 200sx which don't get me wrong wasn't...