Ok thanks very much I’ll give them a ring
Type: Posts; User: stevie t
Ok thanks very much I’ll give them a ring
Long shot but does anyone have or know where to get the 1st piston ring stock bore genuine Nissan. Iv bought a set and buggered one up tia
ok dont suppose you have any pictures, there are 8 points in total for on the plenum and 4 on the throttle body,
im doing a sr20det, bent cam engine and im not sure what pipes go where on the induction, its going into a project im doing, i want to run a boost gauge and have a avcr boost controller, can anyone...
yes i might have been better of paying a little xtra
tbh that would make sense, i was just a bit surprised that there was so few gaskets, iv done pinto,s and mainly chevy engines which normally have more gasket than you need
hi, iv bought a full engine gasket set of ebay and im not sure its a full set, there's no timing gear gasket no sump,thermostat housing, water pump, no o rings for injectors and that just what iv...
hi everyone, im about to strip my s14, im putting the engine and box into another car, i want to use the ecu etc any advice on what i need and dont need in general, iv read a few bits here and there...