Search:

Type: Posts; User: jdm_virgin

Page 1 of 4 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    9
    Views
    133

    Right so then depending on what resistance the...

    Right so then depending on what resistance the ECU sees will determine if it kicks the fans in or not.

    Chance that I've blown this when the wires shorted? Or something further up?

    Sent from my...
  2. Replies
    9
    Views
    133

    These two plugs are under the inlet manifold as...

    These two plugs are under the inlet manifold as nothing is in the rad. I assume the single one (left) is the temperature sensor and the one on the right the switch?
    ...
  3. Replies
    9
    Views
    133

    I think the ECU does send the signal when the...

    I think the ECU does send the signal when the engine gets to a certain temperature. I have a nistune board and I believe you can change the point at which the fan comes on or off.

    The stock one...
  4. Replies
    9
    Views
    133

    No it's not from the sandwich plate, i just...

    No it's not from the sandwich plate, i just happen to have that mounted where the battery used to be.

    Someone has suggested the switch in the radiator so will check that tonight


    Sent from my...
  5. Replies
    9
    Views
    133

    Wiring diagram...

    Wiring diagram usedhttps://uploads.tapatalk-cdn.com/20190612/f7cca9c2fc9a73f39cb0c05e30e2f956.jpg

    Sent from my CLT-L09 using Tapatalk
  6. Replies
    9
    Views
    133

    Electric fan not kicking in

    Need some help with my electric fan wiring. There were two plugs to the OEM fan, black and red and then pink and brown.

    I wired up my mishimoto fans like the diagram below using red and black...
  7. Id ask around all the JDM breakers or driftshop...

    Id ask around all the JDM breakers or driftshop garages as they may have some in stock or had replaced their ones with perspex. GarageD or garage21, JDMdistro etc.
  8. Sticky: Yes I'd be up for this. I have a few friends who...

    Yes I'd be up for this. I have a few friends who aren't forum members but have got some nice cars (s2000, EK4 b16 Turbo, EG3 B18 Turbo) and have come to the lodge a few times so will see if they're...
  9. Replies
    12
    Views
    386

    I've made a bracket that clocks the caliper...

    I've made a bracket that clocks the caliper around about 20 degrees so the PCD is the same. Then shaving the caliper to fit the bracket so i can use the orginal mounting holes on both caliper and...
  10. Replies
    12
    Views
    386

    Because i like doing things the hard way i'm in...

    Because i like doing things the hard way i'm in the process of modifying a set of rear hubs and rear 350Z brakes to fit on my s15. complete ball ache but think it will work
  11. Replies
    48
    Views
    1,796

    left wing a bit here, Citreon C6, peugeot 607, 7...

    left wing a bit here, Citreon C6, peugeot 607, 7 series or insignia. all come as good mpg diesel and are always well specd and decent value

    I'd steer clear of older jags my dad had a few back in...
  12. Replies
    26
    Views
    1,026

    have they given you the exercise where you roll...

    have they given you the exercise where you roll around on your back? lay on hard floor flat on your back, tuck your knees up to your chest then rotate your hips and legs side to side and try and make...
  13. Replies
    8
    Views
    386

    The mrs got me the GT3RS from Christmas, Im...

    The mrs got me the GT3RS from Christmas, Im halfway through box 2 currently, not sure how many hours in I am, just been doing a bit here and there. The gearbox complexion is unreal and having paddle...
  14. if you need the bracket i think I have the one...

    if you need the bracket i think I have the one attached to the cat that was on my S15 and should fit. I will look when i get home

    edit: is yours a 14 or 14a? as may not fit the 14
  15. Decided to have a look at the mini thread,...

    Decided to have a look at the mini thread, reading everything. Just started page 30! Got up to the point where the welds have been ground out from the roof removal. Just as good as a good book. Such...
  16. Replies
    1
    Views
    461

    Auxillery belts

    Going to be changing these over the winter, best to buy OEM or can anyone recommend brands/here to buy.

    Its for an SR20DET

    ta
  17. Replies
    11
    Views
    422

    sounds like the input shaft or something of that...

    sounds like the input shaft or something of that nature has sheared. as being able to change gears without teh clutch would suggest no drive is getting into the box.
  18. Replies
    14
    Views
    382

    The turbo is fed pressurised oil but is gravity...

    The turbo is fed pressurised oil but is gravity drained back into the sump, i would imagine if the drain is blocked then oil is pushing past the seals and being burnt in the turbo.
  19. nissan cube, cheap, practical, auto and cool AF

    nissan cube, cheap, practical, auto and cool AF
  20. Replies
    9
    Views
    346

    the buzzing sounds like resonating at a certain...

    the buzzing sounds like resonating at a certain frequency like two surfaces are touching. is your exhaust touching any part of the body? Also what clutch/flywheel do you have as i know some can...
  21. Replies
    6
    Views
    237

    conceptua tuning on eBay stock all OEM gaskets...

    conceptua tuning on eBay stock all OEM gaskets and other useful bits like bearings etc
  22. Replies
    4
    Views
    209

    Yeah I would say drivers arch loom would be a...

    Yeah I would say drivers arch loom would be a good place to look. I think all s chassis suffer with this problem when the cars are lowered without a loom tuck
  23. Replies
    24
    Views
    791

    Best to use OEM gaskets as they are the best...

    Best to use OEM gaskets as they are the best quality. Can buy direct from nissan or conceptua tuning on eBay will stock them as well as many other OEM bits like wheel bearings etc.

    I would replace...
  24. Grade R is given to any vehicle that has had...

    Grade R is given to any vehicle that has had accident damage repair or has been heavily modified. A body kit and a few bolt ons will still go through as a number where as a stripped out and caged...
  25. Replies
    4
    Views
    221

    Maybe worth checking the wiring for continuity as...

    Maybe worth checking the wiring for continuity as they could be busted
Results 1 to 25 of 83
Page 1 of 4 1 2 3 4