Search:

Type: Posts; User: samburgess

Page 1 of 6 1 2 3 4

Search: Search took 0.02 seconds.

  1. Thread: Ca misfire

    by samburgess
    Replies
    2
    Views
    248

    Cheers andy

    Cheers andy
  2. Thread: Ca misfire

    by samburgess
    Replies
    2
    Views
    248

    Ca misfire

    My brothers ca has a mis/flat spot around 2-3k

    We've changed the coil packs and ignition amp with no luck, he says it gets worse as the car gets warmer, could it be a temp sensor fault?

    It...
  3. Replies
    0
    Views
    103

    Sr not idling

    After fitting the sr back into my 14 it doesn't idle, all sensors are getting power etc.
    I've checked earths and vac leaks a million times it doesn't seem to be related to them

    It has a td05...
  4. Replies
    1
    Views
    168

    https://vimeo.com/124821612

    https://vimeo.com/124821612
  5. Replies
    1
    Views
    168

    Low maf voltage after fuse box move

    After moving the fuse box to under the dash the maf is only getting .5 volts which I think is the cause of the engine searching and dying

    Any help as to where the maf gets it's feed from would be...
  6. Thread: Alarm bits

    by samburgess
    Replies
    0
    Views
    125

    Alarm bits

    Are these bits to do with nats?

    http://tapatalk.imageshack.com/v2/15/02/28/965e7b51579e275c0a8a3ffe5b9c852c.jpg

    http://tapatalk.imageshack.com/v2/15/02/28/919c05e5b7a27fd9558abc8af84b6d1d.jpg
    ...
  7. Replies
    8
    Views
    273

    Yeah that was my thinking mate, just go straight...

    Yeah that was my thinking mate, just go straight from the fuse box, passenger side of the tunnel and it's there lol, just need to run power to the starter then basically isn't it
  8. Replies
    8
    Views
    273

    That makes sense it being to do with the abs it...

    That makes sense it being to do with the abs it heads that way, I had trimmed it out my old loom but wanted to double check before completely cutting it out

    How did you run your gearbox loom...
  9. Replies
    8
    Views
    273

    Will do mate! Yeah sorry about crappy pictures ...

    Will do mate! Yeah sorry about crappy pictures

    Thought they where so I can rip them out finally!
  10. Replies
    8
    Views
    273

    Fusebox relocation

    I'm in the middle of moving my fuse box under the dash on the passengers side of the car in my 14, just got a few bits I'm not sure about.

    I had two looms so I've snipped and made the wires...
  11. Thread: Fpr advice

    by samburgess
    Replies
    1
    Views
    135

    Fpr advice

    Looking for an adjustable fpr, has anybody used the nismo regulator are they any good?

    Any other good options?

    Cheers
    Sam
  12. Replies
    36
    Views
    1,049

    The cas had stripped its teeth, thrown a new one...

    The cas had stripped its teeth, thrown a new one on can get it to fire now!
  13. Replies
    8
    Views
    353

    Yeah thought that would be the case with it all!...

    Yeah thought that would be the case with it all!
    I'll get it all back together on standard injectors and maf make sure she runs then off to the mappers with the proper bits
  14. Replies
    8
    Views
    353

    Thought that would be the case, would it run with...

    Thought that would be the case, would it run with just the injectors in? Just run shit
  15. Replies
    8
    Views
    353

    Tuning question

    Silly question really but it's been playing on my mind

    I'm currently in the stages of putting my car back together, I'm aiming for more power so going down the nistune route. Basically I've got...
  16. Replies
    36
    Views
    1,049

    I'll give it a go mate, the car doesn't start at...

    I'll give it a go mate, the car doesn't start at all though, would a dead afm cause that?

    And when I flashed the ecu (counted the lights) it had no fault
  17. Replies
    36
    Views
    1,049

    Pulled the cas off the other day it didn't look...

    Pulled the cas off the other day it didn't look that bad, I didn't take the cas apart though just took it off the

    Cheers for the help btw guys appreciate it, hope you all had a good Xmas
  18. Replies
    36
    Views
    1,049

    Yeah it's got spark, pain in the arse haha

    Yeah it's got spark, pain in the arse haha
  19. Replies
    36
    Views
    1,049

    Would a dead ignition module stop it sparking? I...

    Would a dead ignition module stop it sparking?
    I tried putting the fuse back in still nothing pointz, timing would suddenly change though? Seems a bit weird
  20. Replies
    36
    Views
    1,049

    Would that cause it to throw flames out the stall...

    Would that cause it to throw flames out the stall do you think konrads?
  21. Replies
    36
    Views
    1,049

    My bros car mate I've got a 14 his got a 13...

    My bros car mate I've got a 14 his got a 13
    Around 8psi mate, it's not chipped yet and has a 255 walbro pump init
  22. Replies
    36
    Views
    1,049

    My brother is running - front mount, turbo back...

    My brother is running - front mount, turbo back exhaust, larger rad, air filter

    Pulled the fuel pump fuse it it went to start once then just turned
  23. Replies
    36
    Views
    1,049

    Been up and had a look at the car, Ecu reads...

    Been up and had a look at the car,
    Ecu reads back 55 so can't find any faults
    Taken cas off nothing seems broken on it.
    Checked boost leaks again can't find anything
    Afm looks clean

    I...
  24. Replies
    36
    Views
    1,049

    I've just read what you wrote, I'll give that a...

    I've just read what you wrote, I'll give that a go tomorrow see if it flashes up with anything cheers mate
  25. Replies
    36
    Views
    1,049

    http://tapatalk.imageshack.com/v2/14/12/23/5dddf61...

    http://tapatalk.imageshack.com/v2/14/12/23/5dddf6175e5f6a1b4cff11e5fb6f5e69.jpg

    That's what I've got, used to wipe the nats and stuff
Results 1 to 25 of 136
Page 1 of 6 1 2 3 4