M8 x1. 25 i think
Type: Posts; User: bigjoe
M8 x1. 25 i think
M8 mate lol
Buy a silenced de cat, tones it down just enough
If i remember correctly tap it out to m5 and pop a grub screw out of a junction box or similar in there, jobs a good'n
No do it, stops leaks over 1bar, plus gives you a little bit of low boost flutter
I checked my disks they are 79mm hub but fit on the studs nice so no dramas thanks guys
e36 m3 3.0 not the 3.2 evo so 1998
Brake Pads Set Front ADT342160 Blue Print think they are the ones al check monday for you
Massive improvement over standard set up disks are around 45 quid a side, and mounting brackets pop up second hand now and again, so cheap brake upgrade, i use toyota hilux pads in mine, fit straight...
Excellent work guys
ok so one of my 314mm disks m3? on my 14a is warped I can get a replacement one from factors and re drill the pcd myself but the m3 disks center is 79mm, how do i get around this? any help would be...
sorry its 66.1 id i think ?
Hey Dan, do you still do spigot rings for m3 disks? think they are 79OD ~68ID ???
thanks Joe
you need to get it running then put a multimeter across the batteyto see what the alt is kicking out , should be around 14v , if so its the battery at fault , if its 12 or less then alt will be the...
sounds like valve stem seals to me , its a head off job to fix sorry
hey , I have had experience with both the profec b spec II and the GFB g force II , both very good bits of kit , i prefered the profec simply for size , but i like the fact you can change the...
landcruiser FTW cheap as chips too
Yes it was the dust cap, water was getting in and drawing the grease out, get dust caps mate
Look in the sticky section for the workshop manual all manner of good stuff in ther mate
Its not the fuel cut mate, thats like hitting a wall lol
thanks
just done some digging around into the vag conversion, does anyone have a wiring diagram?
OK, So the last few days I have had a problem with my car bogging down/hesitation around 2500 RPM after 3 grand, It builds boost and goes fine, Right through to the limiter.
I have cleaned and...
How much we talking ??? I have seen the looms on here, did you make your own loom ?
Hi all, Has any one had any experience with these?
any problems?...
Yes they are a little shorter that stock ones, and yes i used the same sensor both sides, as you can see on yours the pick ups go right through the sensor , no polarity issues as its basically only a...