Search:

Type: Posts; User: TomB

Page 1 of 20 1 2 3 4

Search: Search took 0.04 seconds.

  1. Replies
    9
    Views
    406

    Update: The rad is definitely larger than the...

    Update:

    The rad is definitely larger than the correct one for a CA S13. So I suspect as noted above, that it’s a Skyline Rad.
    New one fits like a glove.

    85157
    85158
    85159
    85160
  2. Yep, winner.. my other switch must have come from...

    Yep, winner.. my other switch must have come from a PS. Swapped it over and all good.. well, almost. My pop ups only pop up on the dash switch, ot when you turn on the lights at the stalk!
  3. Does anyone know what this plug is for? Headlamp stalk

    The one wrapped in foam?

    I’m wondering if it’s to do with headlamp washers?
    My original part has it, and the car had headlamp washers once upon a time, but the replacement part I have doesn’t...
  4. Replies
    9
    Views
    406

    Yeah I do actually.. probably worth whipping the...

    Yeah I do actually.. probably worth whipping the ally one out and comparing it!
  5. Replies
    9
    Views
    406

    I’ll have a look into this.. thanks

    I’ll have a look into this.. thanks
  6. Replies
    9
    Views
    406

    It’s sat in the holes where it should be, the...

    It’s sat in the holes where it should be, the lower rad hose boss sits slightly below the bottom edge of the rad, so when the hose is on the hose sits on the brace below it, stopping it going any...
  7. Replies
    9
    Views
    406

    Japspeed rad fitment problem - CA

    CA S13, has an old Japspeed stainless rad fitted but the problem is it sits high on the drivers side.
    Looks to be a clash between the bottom hose and the brace that sits below it.

    Done some...
  8. Replies
    4
    Views
    529

    It’s the front… I’m wondering if the kit is...

    It’s the front…

    I’m wondering if the kit is for an R33 or R34 and the Zed that they came from had the Skyline hubs fitted in order for the kit to go on.

    Need to find out now if the R33/R34 fit...
  9. Replies
    4
    Views
    529

    AP brake fitment issue (Z32 setup)

    Hello all, looking for some help..

    I have a big brake kit that came off of an Z32 Auto TT and I’ve gone to fit it on my S13 which has Z32 hubs and the caliper bolts to the brackets are not in the...
  10. Replies
    4
    Views
    315

    Woo that asbestos related business is a bit...

    Woo that asbestos related business is a bit cheeky! Garrett taking liability for Honeywell's Bendix braking problems...
  11. Thread: New Nissan Z

    by TomB
    Replies
    76
    Views
    4,749

    This is it really, a la Nio of China.. dedicated...

    This is it really, a la Nio of China.. dedicated pods in car parks where you drive in, the battery is swapped out automatically and you're off on your way in a relatively short space of time. As a...
  12. Anyone going to Go Japan Brands Hatch? 13th Sept

    https://brandshatch.msv.com/BH-20-gojapan

    Made a late decision to go along as it looks pretty good, any other West Midlanders going?
  13. Replies
    0
    Views
    115

    CA VS SR Viscous Fans

    I've got two viscous fans ere, one came from a CA S13 and the other an SR S14a.

    They look largely the same, bar the mounting flange as one is bigger than the other. From what I recall, the smaller...
  14. Looks like the BC website have every component...

    Looks like the BC website have every component you could need, thanks gents.
  15. Thanks for all the feedback guys, I'll get them...

    Thanks for all the feedback guys, I'll get them off and see if they can be blasted an re-coated as none of them appear to be broken, just very crusty! I was reluctant to do this, as I've found powder...
  16. Long shot..replacement springs to fit Apex coilovers

    I have a set of Apex coilovers on my 13 from the glory days of Bren’s wonderous group buys, the springs are shot.. coating is ruined and they are rusty.

    I think they are too rough for powder...
  17. Replies
    8
    Views
    667

    +1 for Muc Off dry oil, has been good so far an...

    +1 for Muc Off dry oil, has been good so far an inexpensive.
  18. Replies
    4
    Views
    8,015

    Sparco Rev Vs Evo Vs Grid

    Hello all.. it's been a long while since I was active on here and time for me to pull my finger out and get the car operational again. Part of which is upgrading the seats,

    I currently have a...
  19. Clamping oil lines when changing radiator (Mercedes)

    Lads and ladies, I’m wondering if someone can offer some advice.

    I’m rebuilding the front end of a W164 Merc ML320 and need to change out the radiator which has oil lines going to it.
    I know one...
  20. Replies
    91
    Views
    94,334

    Sticky: My S13 taxed & tested once again... owned her...

    My S13 taxed & tested once again... owned her since 2005 :)

    2018 should be a year of getting “back in the game”

    Now based in Warwickshire
  21. Replies
    131
    Views
    41,660

    Great story behind this, and great respect for...

    Great story behind this, and great respect for the plans. All the best with the project and the little things that are going to start turning up!
  22. Replies
    22
    Views
    2,613

    Poll: Spot on guys! erryone loves free stuff

    Spot on guys! erryone loves free stuff
  23. Cheers bud, will have to get a quote from...

    Cheers bud, will have to get a quote from Sodablasting and see what they want
  24. Cheers Paul, yeah i'd be keen to know about the...

    Cheers Paul, yeah i'd be keen to know about the blaster in Cov
  25. Recommend a good blaster & powdercoater in the West Mids (or close)

    Can anyone recommend a good blaster & powdercoater in the West Mids?

    Got my rear frame and arms off the car for refurb at the mo, and want it all tarted up.
    Been getting quotes from £100 up to...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4