Cheers andy
Type: Posts; User: samburgess
Cheers andy
My brothers ca has a mis/flat spot around 2-3k
We've changed the coil packs and ignition amp with no luck, he says it gets worse as the car gets warmer, could it be a temp sensor fault?
It...
After fitting the sr back into my 14 it doesn't idle, all sensors are getting power etc.
I've checked earths and vac leaks a million times it doesn't seem to be related to them
It has a td05...
https://vimeo.com/124821612
After moving the fuse box to under the dash the maf is only getting .5 volts which I think is the cause of the engine searching and dying
Any help as to where the maf gets it's feed from would be...
Are these bits to do with nats?
http://tapatalk.imageshack.com/v2/15/02/28/965e7b51579e275c0a8a3ffe5b9c852c.jpg
http://tapatalk.imageshack.com/v2/15/02/28/919c05e5b7a27fd9558abc8af84b6d1d.jpg
...
Yeah that was my thinking mate, just go straight from the fuse box, passenger side of the tunnel and it's there lol, just need to run power to the starter then basically isn't it
That makes sense it being to do with the abs it heads that way, I had trimmed it out my old loom but wanted to double check before completely cutting it out
How did you run your gearbox loom...
Will do mate! Yeah sorry about crappy pictures
Thought they where so I can rip them out finally!
I'm in the middle of moving my fuse box under the dash on the passengers side of the car in my 14, just got a few bits I'm not sure about.
I had two looms so I've snipped and made the wires...
Looking for an adjustable fpr, has anybody used the nismo regulator are they any good?
Any other good options?
Cheers
Sam
The cas had stripped its teeth, thrown a new one on can get it to fire now!
Yeah thought that would be the case with it all!
I'll get it all back together on standard injectors and maf make sure she runs then off to the mappers with the proper bits
Thought that would be the case, would it run with just the injectors in? Just run shit
Silly question really but it's been playing on my mind
I'm currently in the stages of putting my car back together, I'm aiming for more power so going down the nistune route. Basically I've got...
I'll give it a go mate, the car doesn't start at all though, would a dead afm cause that?
And when I flashed the ecu (counted the lights) it had no fault
Pulled the cas off the other day it didn't look that bad, I didn't take the cas apart though just took it off the
Cheers for the help btw guys appreciate it, hope you all had a good Xmas
Yeah it's got spark, pain in the arse haha
Would a dead ignition module stop it sparking?
I tried putting the fuse back in still nothing pointz, timing would suddenly change though? Seems a bit weird
Would that cause it to throw flames out the stall do you think konrads?
My bros car mate I've got a 14 his got a 13
Around 8psi mate, it's not chipped yet and has a 255 walbro pump init
My brother is running - front mount, turbo back exhaust, larger rad, air filter
Pulled the fuel pump fuse it it went to start once then just turned
Been up and had a look at the car,
Ecu reads back 55 so can't find any faults
Taken cas off nothing seems broken on it.
Checked boost leaks again can't find anything
Afm looks clean
I...
I've just read what you wrote, I'll give that a go tomorrow see if it flashes up with anything cheers mate
http://tapatalk.imageshack.com/v2/14/12/23/5dddf6175e5f6a1b4cff11e5fb6f5e69.jpg
That's what I've got, used to wipe the nats and stuff