Thanks matey! Ill give it a go tonight anyway, just preparing myself for what i might be up against, sounds easy enough tho :)
Si :thumbs:
Type: Posts; User: S13Si
Thanks matey! Ill give it a go tonight anyway, just preparing myself for what i might be up against, sounds easy enough tho :)
Si :thumbs:
Thanks, Rich im in Kidderminster mate :)
Go easy on the guy! Its his motor to do what he likes with.
If you like it mate, then thats all that matters :thumbs:
Si :)
Just a quicky,
I'm fitting some 4-5 stud Conversion spacers to my car tonight, For this I will be needing to remove/knock out 1 of the studs on each hub to replace with a longer 1.
I know I...
Heres the damage:
http://i2.photobucket.com/albums/y49/Sipha/alloy.jpg
Anyone know if its an easy repair and where might be able to help ?
Thanks
Si :)
bump :)
I would say yes, pretty much certainly with those sizes/offset.
:)
Was pretty low looking and had a loud exhaust from what i could tell :wack:
Was it you ? :p
Does anyone know of anywhere good in this area?
I have a small crack on the edge of 1 of my alloys that needs welding up
Thanks all
Si :thumbs:
Ahh sorry matey, understood now ive gone back and read the post properly
Got blinded by pictures of shiny coilovers :smash:
Id be interested in a set if you were to go ahead with it :thumbs:
Which 1 is this beauty ? :smitten:
http://i2.photobucket.com/albums/y49/Sipha/16.jpg
http://i2.photobucket.com/albums/y49/Sipha/13.jpg
http://i2.photobucket.com/albums/y49/Sipha/15.jpg
Si
Cheers Arry, i guess i may as well for peace of mind :)
After reading this from another post, im wondering whether i need to do this myself, my newly built CA has covered 600miles ish now, should i check the headbolt torque ? I wasnt told to do so when i...
minus offsets ftw :D
A Z32 AFM is only needed when you go 'stage 3' ie one of Jez's stg 3 chips supports mods which include Z32 AFM, 444 injectors etc... good for 300bhp.
dont run anything over standard imo if you...
This is why i added this part :nod:
Big ends are bearings too, (I'm of course presuming by big ends ppl always mean the bearing part).
68/69 Dodge Charger 440 Magnum
68/69 Chevrolet Camaro SS
:smitten:
Hi Bren,
How much are theres fella ?
Thanks
Si :thumbs:
Welcome aboard matey :)
Your gonna have loads of fun with your new toy im sure :thumbs:
I too have ACL duraglides in mine, both bigends and mains, no quibbles here :thumbs:
What you describe is exactly what i had, the oil found its way onto the bottom of the bellhousing and onto the floor, and yes it was the rear of the sump seal that was at fault (the half circle...
His Forum name is Mad k
Should be a space in there :)