Search:

Type: Posts; User: skyshack

Page 1 of 20 1 2 3 4

Search: Search took 0.73 seconds.

  1. Front you need the whole S14 knuckle, axle is...

    Front you need the whole S14 knuckle, axle is different size and S14 hub won't fit on S13. Or you get S13 5 stud hubs off e-bay that fit S13 axle.

    S14 front knuckle has bigger M14 bolts to strut,...
  2. Replies
    7
    Views
    259

    That's what I was worried about. :smash:

    That's what I was worried about. :smash:
  3. One on road still being used and abused as a...

    One on road still being used and abused as a daily driver. M reg Aug '94, bought it May 2010 (week after my 1st one was crushed at 180K miles), had 130K miles on it, now on 195K miles. Needs quite a...
  4. Replies
    7
    Views
    259

    "Gentleman of the Road"

    Has the meaning of this changed?

    Yesterday I got pulled over for a vehicle inspection. The car was my daily driver a 1994 Nissan 200SX S13. It's slightly crusty, 3" turbo back stainless exhaust.
    ...
  5. Replies
    16
    Views
    501

    This is a fundamental question. No: As Ash...

    This is a fundamental question.

    No: As Ash says there will be something else worth looking at. S13 has style (sleek low fastback with pop-ups), practicality (2+2 + hatch), low cost. It's not safe...
  6. Replies
    16
    Views
    501

    After rust proofing, next job is replace all...

    After rust proofing, next job is replace all coolant hoses. They are all 20-30 year old rubber. I've had 4 fail in last year at 25 years old.
  7. Pin hole in rad or rad top/end tank seal?

    Pin hole in rad or rad top/end tank seal?
  8. Thread: S13 Executive

    by skyshack
    Replies
    3
    Views
    223

    Depends on when it was sold, early ones will be...

    Depends on when it was sold, early ones will be on H plate, late on J. All "Exec" are series 2 and will have VIN like, JN100RS13U020nnnn with small brakes or JN100RS13U022nnnn with 280mm brakes built...
  9. Replies
    10
    Views
    283

    It posts message but says "database error".

    It posts message but says "database error".
  10. Replies
    10
    Views
    283

    Utterly borked.

    Utterly borked.
  11. Replies
    6
    Views
    229

    Sticky pad or piston? Pads should slide in the...

    Sticky pad or piston?
    Pads should slide in the calliper, any binding can hold them on and as the back plate expands when hot it gets worse under frequent application.
    Pistons should move back under...
  12. Replies
    4
    Views
    107

    That's not the same as S13. S13 both ports are in...

    That's not the same as S13. S13 both ports are in line and are stubs that a 16mm hose fits on.

    Simple to test. Check it's got continuity on the heater coil and is not shorted to the body. Look...
  13. Replies
    4
    Views
    107

    That's not the same as S13. S13 both ports are in...

    That's not the same as S13. S13 both ports are in line and are stubs that a 16mm hose fits on.

    Simple to test. Check it's got continuity on the heater coil and is not shorted to the body. Look...
  14. Replies
    9
    Views
    174

    And the S13 is so simple all you need is a...

    And the S13 is so simple all you need is a multimeter and a test bulb.

    When checking for 12V or feed from a dropper resistor put a bulb on it. Poor connections / splices in loom can show 12v on a...
  15. I thought the whole idea of Ehra-Lessien was that...

    I thought the whole idea of Ehra-Lessien was that they could claim it as 2 way while doing a circuit as the road is a long oval. Like a DC with very wide median strip.

    Seems they need some paint...
  16. Replies
    2,113
    Views
    225,275

    I must learn to stop clicking these links to...

    I must learn to stop clicking these links to e-bay and start pasting them to a private window. My mail from E-bay is full of crap "Selected for you: Peugeot Cars and more" and "Renault Classic Cars...
  17. Replies
    79
    Views
    12,758

    I got a brand new stock rad off e-bay years ago,...

    I got a brand new stock rad off e-bay years ago, OEM fit.
  18. Replies
    9
    Views
    174

    Pull the fuel pump fuse. Mark position and remove...

    Pull the fuel pump fuse. Mark position and remove CAS. Switch on, put a rod against ear lobe and on each injector in turn, listen for clicks as you turn CAS. Unplug and put a 5W bulb in the plug, if...
  19. Replies
    11
    Views
    301

    Test feeds to coils and injectors with a 21W...

    Test feeds to coils and injectors with a 21W bulb. I had a corroded splice in loom under engine bay fuse box. Meter showed battery volts on all but bulb showed that the injectors didn't have current....
  20. Thread: S15 v gt86

    by skyshack
    Replies
    70
    Views
    7,089

    But Wisefab can't deliver 70 degrees on a GT86 or...

    But Wisefab can't deliver 70 degrees on a GT86 or 350Z or 370Z. They can for BMW and 200SX.

    And "a few washers" on a GT86 steering rack will only match stock 200SX.
  21. Replies
    7
    Views
    180

    For no cutting you are best off with SAAB or...

    For no cutting you are best off with SAAB or Volvo intercooler that sits between slam panel and rad.
  22. Replies
    30
    Views
    739

    I prefer Carplan "get in there" graphite...

    I prefer Carplan "get in there" graphite penetrating fluid to plus gas.
  23. Thread: S15 v gt86

    by skyshack
    Replies
    70
    Views
    7,089

    Seeing as this has been resurrected. But a...

    Seeing as this has been resurrected.


    But a stock S13 will be sliding with much more style as its yaw angle will be around 40 degrees instead of 30. So how easy is it to maintain the slide in a...
  24. Replies
    8
    Views
    183

    And then there is this SUV version?...

    And then there is this SUV version?
    https://carbuzz.com/news/nissan-390z-concept-rumored-for-tokyo-motor-show-reveal
    https://cdn.carbuzz.com/gallery-images/original/273000/100/273171.jpg
  25. Re :?? Harmonic damper. With every firing...

    Re :?? Harmonic damper.

    With every firing stroke the crank gets an impulse that twists it. At some engine revs these match the natural frequency or a harmonic of the cranks torsional frequency,...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4