if that is the case couldn't you trim a bit off the overfenders lip? (unless they are straight of course)
Type: Posts; User: Smithylee
if that is the case couldn't you trim a bit off the overfenders lip? (unless they are straight of course)
Thanks for the input piman will have a look now.
Thanks
I like! Where can I buy!
Any pictures of kouki rear with navan skirts?
and i bet pretty expensive
im after a rear bumper that will blend in with the navan sideskirts,
and i prefer the oem plus look, however im not keen on the navan rear and spats and would like the rear bumper to be single...
How would I go about pressure testing it?
I can see myself having a boost leak as I have the high mount kit from Japspeed consisting of 2 bits of piping and 4 short silicone hose fixings all of which are extremely tight And not going...
I have a exhaust leak from the turbo to elbow gasket.
Would this cause my sr20det to have bad fuel consumption due to throwing out the readings on the lambda sensor?
Thanks lee
Do you guys going very club discount to turbo lines?
Thanks
Nobody?
i am going to be taking the turbo off within the next couple of days to change gaskets and stop a blow i have.
now while im taking the turbo off i may as well change the oil and water feeds to the...
i had a little time to play yesterday and removed the ball and spring.
boosts perfectly fine with standard actuator at .5 bar of boost.
so it must be that the spring is too strong?
thanks lee
But surely that wouldn't make a difference as there would be constant pressure on the ball and spring keeping the gap open for pressure to be released through..
im pretty certain it is. the one i have is this...
http://www.ebay.co.uk/itm/220834255382?_trksid=p2060353.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
i have a piece of hose coming from the...
since i have installed my manual boost controller i have been having problems over boosting.
i have set the controller as fully out as possible (ball and spring jobby) so should be letting most...
ive also just remembered that there small a small bit of piping coming from the inlet pipe, i have now just gone and blocked it off even
though i feel that the long blue line should connect to it...
hiya guys ive just fitted my japspeed high mount intercooler but im a bit suspect about the boost lines.
...
It's definitely not kouki. Is it a vertex kit? Having looked around.
what kit is on the 14a?
http://i1173.photobucket.com/albums/r590/redhanded771/photo_zps73eb294e.jpg
thread revival... how do you drain out the gas from the system?
thanks
That said maybe slightly out of budget.
Lotus exige?
thanks fella will look into them now
Hiya guys i have a lad interested in my gearbox etc etc
problem is he lives in the Netherlands...
what or who are the best delivery service to use?
Any recommendations or advice would be...