Just reuse old ones, i guess when you go with arp studs its reccomended to line bore mains..
Sent from my iPhone using Tapatalk
Type: Posts; User: Desa
Just reuse old ones, i guess when you go with arp studs its reccomended to line bore mains..
Sent from my iPhone using Tapatalk
So is everything ok with ECU?
CAS worn out
CAS spline on exhaust camshaft worn out
Sent from my iPhone using Tapatalk
Yes its possible, i have done it without dropping subframe, but i would suggest to drop it, it will make whole job lot easier
IF you paid by paypal Open a case there and send them back via tracked courier.
But First Communicate with Danielle i guess probably she just took a photo of first piston and thats all, better get...
Looks like some heatshield from turbo or the one on engine mount below the turbocharger.
Sent from my iPhone using Tapatalk
I bought this rebuild kit :) but never got round to rebuild it, if you like to gamble :D i can sell you it for fair amount of money, but actually i would just send it to some company to rebuild it :)...
Yes
1220060J10
Part number also is the same :)
Sent from my iPhone using Tapatalk
Sent you a private message :)
I have put an sr20de crank on s14 sr20det engine they are 1:1
Sent from my iPhone using Tapatalk
Easy job to do it, i would recommend to change front cover gasket and oil seal too when reassembling all.
Btw i couldnt reply you, your pm box is full
Sent from my iPhone using Tapatalk
http://www.ebay.co.uk/ulk/itm/331647468178
rubber boot for shifter assy
Sent from my iPhone using Tapatalk
Yes :)
Just clear your inbox so i can reply you
Cheers
Sent from my iPhone using Tapatalk
I am using s14 ones on my s13 they are thicker, just need also outer tie rod ends from s14. Direct fit and dont bend that often as s13 ones.
Sent from my iPhone using Tapatalk
Take elbow off and check if parts that closes wastegate is still there, friend just had this problem
Im using cooper/brass Pipes 8mm for feed and return and 6mm for Fuel Tank Ventilation
Just using brake pipe flaring tool(there is ends for 8mm and 6mm) to make beads
1 Yes
2 Discs 280mm and would suggest braided lines as s13 ones won't fit
4 won't fit s15 has 280mm diameter, would suggest to put front r33 gtst calipers, bigger discs, aluminum calipers apart...
Correct just without first letter N in part number
Heat it with blow torch and then try again it usually helps :)
Hey sorry if I'm in wrong section with my stupid question
Wanted to ask how much are used s13 kouki rear lights worth?
No cracks,
RH Light, LH Light, Middle section, genuine nissan rear...
If calipers were off maybe they are on wrong sides, mate had this problem on his s13 :D
Sorry i just red all carefully, yes its just a pry bar or chisel job.
Take the throw out bearing carrier slider part or what to call it off :) and under it there should be one snap ring that is built in outer part of bearing, take it off and all should come off easily
Sveiks :)
Don't know yet what to do with this car, probably ill sell it, if not then ill use it as Drift car :)
Here we have about 200-300pcs S Chassis in Total but about 5% maybe of them drive,...
Hey
Im already few years here but haven't showed up here
Im Valters 29yo
I would say I'm pretty addicted to 200sx :)
Have had in few years about 25xs13 2xs14 2xs14a 2xR33 mostly for all...
I'm in :)