Thanks lads i will do a search aswell, Do i have to change the handbrake cables?
Alternatively ive heard about the 330mm brake upgrade using M3 discs for the front with a modified mounting bracket...
Type: Posts; User: Nicky L
Thanks lads i will do a search aswell, Do i have to change the handbrake cables?
Alternatively ive heard about the 330mm brake upgrade using M3 discs for the front with a modified mounting bracket...
Also are they a straight swap or will i need modified brackets?
Cheers
Nicky
As above. any help appreciated.
Just my personal opinion but its all good converting the engine to something with more pistons and cc but you are adding a $hit load of weight so by the time your done the advantage isnt as big as...
Im being told by a few people its more likely to be the input shaft bearings on the gearbox.
Has anyone tried to source the input shaft bearings? if so where from or is it a dealer only thing?
Ye Bren it goes away when i press the clutch, Ive been assured the box was in good condition.
After spending more time than was actually needed making sure my auto to manual conversion was perfect ive taken the car for its first drive only to find out the release bearing sounds absolutely...
After spending more time than was actually needed making sure my auto to manual conversion was perfect ive taken the car for its first drive only to find out the release bearing sounds absolutely...
Where have most people wired from the TCM plug or straight into the ECU's wiring.
Cheers
Nicky
^
^
^
The way i understand it at the moment is im splicing into the TCM plug not the ECU is this correct? then i need to run 2 wires to the box 1 red with green stripe and 1 green, im going to earth the...
?
As above, Can i disconnect the 4 plugs that connect next to the suspension turret and remove the loom?
Nicky L
^
Im finding this guide very confusing is it the red with green stripe wire or the yellow with green stripe wire? or do i need to splice into the ecu? the posts that say i have edited original posts...
Anyone know the torque setting for the flywheel bolts on a manual flywheel being mounted to an sr20?
?
Do the three sensors from the auto box get spliced into the manual box? i have three wires hanging down after taking the auto box out and the connectors are different are they different sensors to...
Im half way through converting my car to manual and i just wanted to know if the gearbox crossmember from my auto box will fit my manual?
Any help appreciated
Nicky
Whats the easiest way of dropping the steering column? i cant remove the auto brake pedal due to the brace that sits over the steering column any ideas?
any help appreciated
Nicky
as above anyone know how to bleed the clutch?
i was just looking through ken's guide and he says to remove the starter motor is this essential as i didnt remove mine and the box came out ok, also i had to cut a wire with heat protection on it as...