Printable View
As above, I could use some help getting my head around a few bits of wiring-
-fuel level, I understand this needs a 100ohm pull up resistor. But where can I get one I cant find them online?
2-Sidelights wire to dash, can I just use the "oem illumination" wire?
3- vehicle speed, not looked much into this as yet.
not specific to the dash but..
100ohm resistor is just a 100ohm resistor, the pull up bit refers to using the main DC voltage to 'pull up' the signal. if it was pull down it'd pull it down to ground.
you just need to get the right wattage resistor but I'd imagine it'd just be a normal 1/8-1/4w resistor.
It's been years since I wired the 180 up so can't help on the other two :D
Thanks mate, my friends grabbing me the resistor today so hopefully that'll be sorted.Quote:
Originally Posted by alanjuggler
Have figured out the lighting just the vehicle speed now which id prefer to use oem sensor.
Sent from my SM-G960F using Tapatalk
it depends on what signal you're trying to use - from what I remember, the OEM cluster is what creates the signal for the OEM ECU, I think they describe that here:
https://www.msextra.com/forums/viewt...?f=131&t=52690
it all depends on what signal the thing can process as to what you use - if you check the S13 OEM manual, it's got the wave patterns for the ECU speed input and the speedometer input type so you can match it up.