Printable View
not just an engine thread but a total car rebuild thread starting with some shiny bits
http://premium1.uploadit.org/nollett123//DSC00692.JPG
http://premium1.uploadit.org/nollett123//DSC00690.JPG
http://premium1.uploadit.org/nollett123//DSC00693.JPG
http://premium1.uploadit.org/nollett123//DSC00694.JPG
http://premium1.uploadit.org/nollett123//DSC00695.JPG
http://premium1.uploadit.org/nollett123//DSC00696.JPG
Looking good mate!:thumbs: :)
the intake manifold and de-jetro will be put on my standard engine first while i sort out the rebuild, got loads to do, finnish the body kit, welding the rollgage suport plates, then theres the adjustable rear camber/caster arms, where do i start:wack:
:eek:
so there is no budget then:D
What are you going to be using the car for?
fun:nod: :D i want to go around europe with the girlfriend and visit a few tracksQuote:
Originally Posted by polo
Lookin good mate:thumbs:
Why 2 sets of arp bolts?
1 head set and 1 mains set:thumbs:Quote:
Originally Posted by pablo13
decided to have a go fitting my new plenum
http://premium1.uploadit.org/nollett123//DSC00700.JPG
http://premium1.uploadit.org/nollett123//DSC00698.JPG
as you can see the boss for the temp sensors is to close to the thermostat housing and will need to be plugged and i will fit the sensors into 'WATER TEMP SENDER PORT SLEEVE' from GAUGEPLACE
http://premium1.uploadit.org/nollett123//DSC00699.JPG
modding the fuse box to give me more room
http://premium1.uploadit.org/nollett123//DSC00701.JPG
http://premium1.uploadit.org/nollett123//DSC00702.JPG
i have cut it flat and will mount it closer to the wing on a flat plate, had to do this as it fouled the throttle
what make is that manny? can you use the origanal injectors, fuel rail, ICV etc, etc with it:confused:
the ivc needs a simple mod, the fuel rail needs cutting so the fuel feeds from the left hand side:nod:Quote:
Originally Posted by polo
if your good with your hands YOU CAN DO IT:D
Looks good but where did you get that intake manifold ?
http://search.ebay.co.uk/_W0QQfgtpZ1...Q5fperformanceQuote:
Originally Posted by AntS13
very nice indeed. That manifold looks well made, what are your thoughts after fitting?
its not all done yet, i need to make a new cold pipe, and a few other things, it does seem well made the only big problem is the temp sensors fowling the thermostat housingQuote:
Originally Posted by blue boy
nice stuff dude, ill be watching this thread with interest - good luck :thumbs:
trying to find some where to get some boost nipples so i can connect my sensors to the plenumQuote:
Originally Posted by MattyGee
That manifold looks like it takes top feed injectors rather than side feed.
i was going to say the same:confused:Quote:
Originally Posted by Jezz_S13
takes the standard fuel rail :nod: found you just need to bend the metal feed pipe a little as it hits the manifold:)Quote:
Originally Posted by polo
well had to mod the fuel rail but it fits and made a suport that also holds my avcr, d-jetro and water injection sensors
http://premium1.uploadit.org/nollett123//DSC00707.JPG