Printable View
hi ive got a intercooler on my ca18 and under the intake wer the intecooler pipe connects thers a nipple ive got some silicon pipe but wher does it go too?
on my mates it goes to a black round thing near the passenger side headlight under the standerd intercooler pipework and connects to it , thers also another pipe that comes off that too and iv got that goin to nowhere any one have any ides ....
much appriciated sean
carbon canister.
Provide pics of your set up.
You should have a fule pipe loop in place of the canister if its been removed and a short pipe coming from the nipple on the plenum that is blocked off with a screw or reused for the boost gauge or similar.
Search for carbon canister for more details.
It would of gone to carbon canister like your mates! But can be used for boost controller but not boost gauge as it only sees positive pressure!
If you aren't using a boost controller block it off.
Tooooooooooooooooooooo slow Rich :p
Cheers guys its got a mbc under the bonnet connected up so i rekon ile just block it up .. What about the other pipe ? Just block that too ?
Its got a fpr too . One more thing thers a pipe under the manifold with a bonjo on the end and it connects to the engine its twisted i undid it and coolant came out and it dunt leake im just wondering whats it for ?
Cheers
You should have 1 vac line at the back of the plenum which goes to the FPR (it will be about 5cm long)
And block the 1 under the Throttle body (or use this as a feed to your Actuator or boost controller)
Vac line from side of plenum for boost gauge.
Pull any other vac lines out and the Hot start solenoid, if not already done. As it isnt needed.
Beat you too it this time!
Cheers for info buddy .. All done now :)
Do u no out about the pipe under mani that has water/coolant in ?
Just mines abit twisted like someones ment to have done it :/ bit confused lol ii
There is 1 metal hardpipe under the inlet which has 4 hoses off it and a couple hoses to the water/oil cooler, Theirs a fair few pipes under there!
Post a picture of your twisted coolant hose.
...and Rich, you forgot to tell him to block the HSS pipe that goes to the elephant's trunk ;)
I cnt do pics im on my phone :/ ..
It has a large banjo at the end it bolts on half way down the engine just under the manifold .. Its a hard pipe but then connets to a rubber hose wich then i think runs into my plenum or somewhere near ..
I undid it and water/coolant came out but im not sure why its twisted tbh
Sxxt well spotted i meant to but obviously forgot! Cheers JonnyQuote:
Originally Posted by Jonny Wilkinson
Are you talking inlet mani or exhaust mani?Quote:
Originally Posted by 200sxmadz
Sorry exhaust manifold buddy
The banjo on the block will be feed to the turbo and then another pipe the one thats a hardline is the return from the turbo which as you say goes to the back of the plenum i think then goes to the hardline under the inlet mani!
Where is the kink?
Its near the banjo near the engine its more twisted right around then a kink ...
Ove got top mount on but ot dosnt seem to go to turbo ive got a oil one under turbo and a braided one on top .
The hard one os on engine and just runs round to plenum some wher ...
Ile take a better look tomoz
Turbo obviously isn't watercooled then so pipework has been looped just leave it unless its a problem
Ok cheers buddy thanks for the help