-
A little more boost
Hello people,
is it possible to raise the boost "a little bit"?
Maybe to 0,7 or 0,8 Bar... :rolleyes:
Here´s my setup:
-Stock Redtop
-T25G
-3" exhaust system
-FMIC
-air filter
Is it okay to run a little more boost with the OEM map?
thanks
Alex :)
-
In short, yes you can.
Im running at 0.8bar currently but am limited due to stock wmic and on the stock map. However I believe it is possible to run slightly more boost with a fmic on stock map. I think you may get close to maxing out the injectors though.
Dont quote me, but im sure the full metal gasket (Tim) is running just under 1 bar on the stock map
-
Okay thanks.
Next month i want to buy a chip from Jez but at the moment i´m on low budget. :indiff:
A friend is running 0,9 bar of boost all day long but i want to be shure if it´s okay. :nod:
-
Another worthwhile mod would be an uprated fuel pump too mate.
-
I already got a walbro too. :nod:
-
My old one Run at 1bar with no problems. Wallace did say the injectors are almost maxxed and that I couldn't turn the boost up anymore.
-
I also suggest you ask jez if it's mapped for t28. If it is, get one and you will then be running approx 280bhp as opposed to the 250bhp that a t25 will make. Another thing that let's the power down is the actuator. Buy a hks actuator or similar and set the boost with this and you will notice the power holding alot better at the top end of the revs.
-
Jez got redtop stage chips for the T25g. :nod:
I know that it´s not the best methd but i wat a little more power yet, in the next month i´ll get his chip.
But next week i´ll go to the racetrack..... :rolleyes:
-
It will be fine at 0.9bar