the main cap arp studs
Printable View
the main cap arp studs
ahh ok, I'm staying standard with those I think.
Another small part arrived today, sr20de throttle body, prob won't make a massive difference but it all helps.
https://uploads.tapatalk-cdn.com/201...d8a8d997ef.jpg
Sent from my iPhone using Tapatalk
Collected another piece of the puzzle at the weekender.
87mm cp pistons with thanks to stu at Garage SR :cool:
https://uploads.tapatalk-cdn.com/201...7b32c7064d.jpg
The engine is off to the garage on Monday too so fingers crossed it's not too bad inside.
Sent from my iPhone using Tapatalk
Awesome buddy. :)
Whats the Plan ?
I need to rip mine out for a full forged set-up !
Need a lottery win first ! ha
Engine should be coming apart next week to be checked and go for machining hopefully. If the crank etc is good I can then look to order the bearings and start putting it back together. Going to run my current turbo etc until funds allow
If crank is bad???? Stroker????
Sent from my SM-N9005 using Tapatalk
Don't know anything about stroker cranks. Don't want to look in to that either as my crank will be fine.... I hope
Let's hope then.
Sent from my SM-N9005 using Tapatalk
Yeah just looked. New Oem crank would be the way forward.
Progress, took the engine to my mates workshop and just over an hour later it looked like this.
https://uploads.tapatalk-cdn.com/201...61868585bc.jpghttps://uploads.tapatalk-cdn.com/201...5c02ec2aee.jpghttps://uploads.tapatalk-cdn.com/201...d64f48c0f7.jpghttps://uploads.tapatalk-cdn.com/201...2a07c96d4b.jpghttps://uploads.tapatalk-cdn.com/201...c7bba38f53.jpg
Everything has been marked and separated ready for when it goes back together so it goes back together intbe right order [emoji106]
Sent from my iPhone using Tapatalk
Much damage?
Sent from my iPhone using Tapatalk
What was wrong with It? Looks like everything is in good nick. Those pistons look well clean!
Sent from my SM-G920F using Tapatalk
Big end bearings were toast, hopefully the crank is ok as don't really want to be buying a new one.
Interesting progress as i'm pretty much at the same stage as you with the forging.
I'm interested in what clearance you measure from Piston to Block using those pistons. As i have the same ones and i'm not sure if my clearance is a bit too big.
CP give a minimum, but not a maximum clearance.
I'll see what info I get back from the builders and let you know :)
any news?
Not yet :(