Input shaft on a CA18 gearbox, need measurement Please!

Hey Peeps,


Wondering if someone can help, i am after a measurement of where the input shaft sits within the bell housing, as in does it stick out, sit in slightly or is it flush with the face? If anyone could get me that measurement i would be so grateful.
Trying to finish my CD009 conversion and i sold my old box too early.:annoyed:


Thanks
Tony

Pretty sure it sticks out about 1-2cm, dont have the right measurements, tho...

yeah it sticks out, will be the same as a Sr20 box

Thanks guys, i really need the measurement of how much it sticks out by.

Thanks
Tony

it doesnt matter as the splines on the cd009 are slightly backwards on the shaft , just measure your clutch disc vs dept of the crank hole and work from there