Clear side indicator part nos required

[Cookie]

Any one know what the part numbers for the clear SIDE indicators that are the same as the normal indicators are.

I think the 1999-2000 Almera or some of the later micras had these.

Also any one found a better price on the front clear indicators than £30 each from my local nissan dealer.

[Actual_Ben_Taylor]

Think Dan posted theme a while back, try searching the forum.

And no, I don't think anyone else sells them cheaper..

[Actual_Ben_Taylor]

OK, looks like I'm mistaken! Anybody??

[Actual_Ben_Taylor]

No I was right!

As posted by Dan:
26160 - BM400

[Cookie]

Thanks

[This message has been edited by Cookie (edited 04-08-2001).]

[Cookie]

At last they have sort of arrived.
Front indicators fit fine.

As to how to fit the side indicators...

For those who already have clear sides please can you advise the methods you used to fit them them. (Both mounting & wiring)

Thanks

[David_S14]

The sides are almost a straight swap. You can use the existing wiring and the bulb holders. You only need to trim the bulb holders very slightly (stanley knife) to get then to fit.

------------------
David Cater
"Purplish Blue Pearl" 1995 S14
K&N,Mongoose,HKS Fuel pump, Blitz FATT-S,Racelogic Adj. Traction Control & I need an INSANE badge more than Jon does

[Diddn]

Can anyone tell me where to get these clear indicators from. I'm looking for front, side & rears. My local Nissan dealer say they don't do them & they don't know where to direct me.

[David_S14]

As posted above the clear sides are from the new Almera (part no's above)
The clear fronts you can get from the states if you have an S14a
http://www.nissanparts.cc
26135-70F25 left turn signal
26130-70F25 right turn signal.

------------------
David Cater
"Purplish Blue Pearl" 1995 S14
K&N,Mongoose,HKS Fuel pump, Blitz FATT-S,Racelogic Adj. Traction Control & I need an INSANE badge more than Jon does

[Cookie]

Cheaper to buy the fronts from a uk dealer.
Postage is expensive from the states.
However there is an 8 week delay on the availability (What ever) of the fronts from the factory.

Going to silicon seal the sides on i think, as can't think of a better way to mount them.

As a side note does anyone have a link to the 200sx & or 240sx technical manual.

I Want to know if just the front indicator glass has a part number as the back is identical.

[David_S14]

Cheaper to buy the fronts from a uk dealer.
Could not get them as they are only standard fit in the US $30 each and $25 P&P

Going to silicon seal the sides on i think, as can't think of a better way to mount them.
They will fit using the clips on them. The Almera fitting is almost identical to the S14.

As a side note does anyone have a link to the 200sx & or 240sx technical manual.
http://www.silvia.hl.com.au/techinfo.asp

I Want to know if just the front indicator glass has a part number as the back is identical.
Have not seen the glass seperate.

------------------
David
"Purplish Blue Pearl" 1995 S14
K&N,Mongoose,HKS Fuel pump, Blitz FATT-S,Racelogic Adj. Traction Control.

[This message has been edited by David_S14 (edited 18-09-2001).]

[Diddn]

Cookie, did you get your fronts from a UK dealer? If so, which one?

[Cookie]

Nissan Colchester £26.* each ish.

They will order any parts that you can give a part number for (Just make sure you have the right part number).

One of the chaps there has a Jap Sunny GTIR (Looks like a v.nice motor)

[Cookie]

And also the indicator clips are a bit too small and they keep poping out.

As a note I am still waiting for one of the front so have only test fitted them.

But for sure the side clips will not keep the indicator attached.

[Diddn]

So I'm assuming the UK dealer will order the US Part using the US part number as given by David above?

[Cookie]

correct