Amp wiring routing

[Rich C]

Hi

I'm trying to put an amp in the boot of my S14a. I can't find a decent route from the engine bay through the bulk-head and into the cabin. It seems that some of the other harness routing goes through the right wing?

Any ideas what is the best way to route the positive wire?

Cheers

Rich C

[YODI]

Hi,

I drilled an 10mm hole in my bulk head above the accelerator pedal and used a rubber grommet to cover the sharp edges. Its good because the power cable goes throught the bulk head right near the battery.

Hope this helpa a bit.

YODI

[p.nicholas]

mine goes along engine bay under wing and through the same hole as speedo cable
then along the side of gearbox tunnel under the back seat and into boot
:)