Three simple steps...
1. Clean away any rust and debris
2. Take one tin of underseal
3. Paint everywhere
Before.
After.
Not sure whether it is the best paint for an engine bay but looks ten times better and will never rust again Got a few areas to touch up to finish but I am happy with it. Not flash but practical(ish).
Only concern for me is that the heat from the engine may cause it all to melt. Have I done a silly thing?
your thoughts....
PS - thanks Zarc for giving me a hand today, couldnt have got this far with out you. Now I have finshed the welds on the chassis rail we are good to put the engine in on Sat