Right i have decided to break my nissan s13, so will list everything below, I have broken the full car so if theres anything you need and cant see just pm me. All prices are collected but i am willing to post smaller items for additional cost. ALL parts can be collected from RG71TB and anything that will fit in my car can also be collected from GU166NE ( basically everything bar engine and gearbox)
first up, CA18DET engine, its mint was removed from a 52k mile old car, I have receipts for a new water pump and cambelt kit that was fitted back in 2012 car has been sat for two years now so hasnt really been driven much since these were done. I removed the gearbox todo and the crank seal is leaking slightly so the seal will need to be replaced ( easy job and cheap to buy, can be done without taking anything off. Also i compression tested the engine today and the results where good, basically exactly the same readings across the board, engine was stone cold but was getting 10 bar across all cylinders. engine comes with inlet manifold fully built up, no coilpacks or turbo or manifold, or pump or alternator (altho available separately. £SOLD
Manual conversion, gearbox is sound no nasty noises etc, this kit will include the following:
Flywheel and bolts
s13 stock used clutch
Stock 52k gearbox
geabox shifter
Manual propshaft
gearbox mount and bracket
gearbox bolts
gearbox wiring loom
slave cylinder
brand new braided clutch line
manual foot peddle
clutch master cylinder
£250 ( all you will need is a release bearing and brass spigot bush £10 off ebay)
nissan s13 ca18det exhaust manifold, stainless steel bottom mount £SOLD
intercooler for s13, complete with lines, two dents in the cooler but doesn't affect it in any way £SOLD
s13 frankinstine exhaust, mostly 3inch stainless, with a powerflow box welded in the middle, the whole system is just home made by someone and does NOT unbolt.. its one pipe from the downpipe to the backbox so would require cutting to fit in a car or a big van ( i can throw some 3inch flanges in with it if someone wants to cut it) £60
nissan prefactlift pignose front bumper with splitter £sold
nissan prefacelift sidelight/indicator lights £30
brand new nissan ca18det aluminium radiator £SOLD
passenger door, completely bare, no dents etc £sold
Japspeed front tie rods and ends, in new condition one has been fitted and sat outside on the car for a year but no driven, £SOLD
Front adjustable tension rods Japspeed or Apex unsure, good condition, not play in them etc again havent been driven on but sat outside for a year £50
rear adjustable camber arms, unsure of make but their red £SOLD
Nissan s14 welded diff, comes with a choice of either s13 backing plate or s14 £50
Nissan s14/s14a/s15 front metal diff bushes £20
nissan 200sx s13 rear subframe with Driftworks metal bushes £60
Tein coilovers, paint is flaking off badly, no leaks or knocks £300
nissan s13 fuel tank, comes complete with filer cap but no fuel pump craddle £40
walboro 255 fuel pump, complete in craddle £SOLD
s13 fuel tank straps, good condition, one had been welded comes with brackets and pins £30
s13 steering rack, good condition, no tie rods or lines £30
I have got loads more parts, I have literally removed every part from a nissan s13.
i will upload photos tomorrow
any questions either pm me on text me on 07850255657
Cheers
Ryan