-
Dorset & Hants Rep
discs
What car do people get discs off of for 345mm brake upgrade using z32 calipers?
I posted in other sections but no replies!
-
Guest
You just need a 345mm disc kit. Doubt you'd get them straight off another car because you need the calliper spacers as well.
-
Dorset & Hants Rep
I got the spacers, calipers just need discs
-
Graphics Guru
Was actually looking for this myself earlier, haven't bought any yet but found this thread useful:
http://www.sxoc.com/vbb/showthread.p...p+brembo+discs
-
Dorset & Hants Rep
What bmc would people recommend for a 345mm z32 caliper setup?
BM50 / BM57
-
Guest
-
Dorset & Hants Rep
Cool cheers
-
Guest
These ML500 discs seem right
http://www.apbrakediscs.co.uk/front-...-to-3-05.html#
But the ML500's apparently have a PCD of 5x112, but the wheel studs are M14, is this enough to allow them to fit?
-
Guest
They probably need redrilling to fit.
-
Guest
I think they may fit without drilling,the center bore I just checked is the same so it will center on the hub ok
its only 2.3mm off the pcd needed and its on a 14mm stud/wheelbolt and we have 12mm studs
the disc is 2mm thicker than the z32/14 disc
the only thing will be the offset of the disc on the nissan hub maybe off and it will need shims to center the caliper
-
Guest
I'll have to measure my 345mm discs and find out the offset, as we may be on to a winner!
-
Dorset & Hants Rep
Cool of you could measure them slamz that be awesome!
-
Guest
You could ask Dan about it, I don't think he's making the kits anymore so might not mind people sourcing the stuff themselves.
-
Guest
Yep wouldn't hurt to PM him and poss find out what was in the kits
the ml500 uses a 4 pot caliper,the lesser models are 2 pot sliding type so chance its not far off
http://www.ebay.com/itm/2002-Mercede...-/131110719744
-
Graphics Guru
Did anyone find out if these will fit?
-
Dorset & Hants Rep
I just bought a set of ml500 discs so will report back when i have tried fitting.
-
Graphics Guru
Awesome cheers
-
Guest
Winner, not had a chance to measure mine as I've only just got my calipers back
-
Guest
Mine definitely have M14 holes, but does anyone know where to measure for the backspacing/offset?
-
Dorset & Hants Rep
Id imagine from the back of the disc to the bell face using a straight edge across the face of the bell!
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules