As title gentlemen, does anyone know if the rear hub carriers on a ps13/s13 are the same as s14 ones
Or will ps13 rear hub carriers work with a s14 subframe, arms and lower arms
Any help would be much appreciated
Sam
As title gentlemen, does anyone know if the rear hub carriers on a ps13/s13 are the same as s14 ones
Or will ps13 rear hub carriers work with a s14 subframe, arms and lower arms
Any help would be much appreciated
Sam
Anyone ??
No they don't.
All S13 hub carriers have a threaded taper pin for the rubber bushed eye of the shock.
S14 has a rubber bushed lug on carrier and forked end on shock.
Have you mixed up s14 with 300zx z32? as they are forked ended shocks with the shock bush in the hub carrier
,s13 is taper threaded pin with a 12x1.25 nut and separate washer as you posted,
s14 is a threaded sleeve with a 12x1.25 bolt with an attached sort of 'winged' washer
the toe ,traction and camber arm bushes are same width,and the lower arm ball joint hole is same 9 degree taper and hole size
I think they will fit ,but not tried, I think they are different dimensions in overall height and the arm positions
but I haven't compared them side to side
you can fit either the dimensions are practically the same. just one has a peg for the shock to mount on the other has a threaded boss.
That's great just the input I needed lads, thanks again
Basically I'm putting a s14 subframe on a ps13
And will be using ps13/s13 coilovers on it.
The ps13 rear hub carriers I have have all been polybushed so would rather use them
So this means the the coilover mounting point is sorted
And the lower arms and alignment arms will fit
Your need off set sub frame bushes as the 14 sub frame is 10mm wider
some more info here >http://www.driftworks.com/forum/tech...-question.html
and a link to this for everything about suspension >http://zilvia.net/f/showthread.php?t=296725