-
Guest
Simple Z32 maf test
Hi there,
I suppose itīs possible to do a simple Z32 maf test with just a 12V battery and a multimeter? (no car)
Does anyone know what signal voltage should be with no air flow?
Thanks
-
Guest
Test you describe is in the 200SX service manual for stock maf, one voltage no flow, 2nd voltage when blown though. So it should be in the 300ZX service manual for Z32 maf. P2P. 300ZX owners club?
-
Guest
wouldnt mind knowing this myself, i have a spanking new genuine one that is supposed to be faulty - if i can test it and know its fine then i can sell it in good conscience....
-
Guest
http://www.300zx.co.uk/cgi-bin/manua...ault&total=190
12v terminal E
Ground C and D
Signal B
A is idle mixture (300ZX used both mixture screw and lambda)
http://www.300zx.co.uk/cgi-bin/manua...ault&total=190
0.8v on pin B no flow.
Voltage should rise when blown though.
-
Guest
Thanks mate for the service manual
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules