-
Guest
-
Guest
Give Bimecc engineering a ring and find out who your local distributer is. They have most fitments. http://www.bimecc.it
-
Guest
Aces, cheers George!
-
Guest
In fact I seem to remember getting 65mm studs off them with a 1.5 pitch and a 14.3 spline along with wheel nuts to suit. It's what holds my spacers on at the moment.
edit: check the splines though, I think the front and the rear were different IIRC
-
Guest
yup, fronts are 14.3, that's what I need them for. They don't list the studs on their site but I've sent them an email. Was hoping they could also help me with my quest to find some super low profile (max 12mm) M12x1.25 nuts.
-
Guest
http://www.performancealloys.com/ are a bimecc stockist if you just want to phone and see if they have stock.
-
Guest
I changed 2 of my front ones and found they didn't need the washers second time round?? - different length of splines - makes no odds if you have to use them
-
Guest
Where were the replacements you got from Phil? I really don't want to have to do the washer thing. I've tried several suppliers and they just keep fobbing me off and sending me catalogues that say for anything not in the catalogue (which they're not) just ask
-
Guest
I got them from RPM in Ware, but its closed down I think. Surely Rally Designs etc do these??
-
Guest
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules