Search:

Type: Posts; User: TomK

Page 1 of 20 1 2 3 4

Search: Search took 0.24 seconds.

  1. Replies
    7
    Views
    1,204

    Isn't there a compatibility issue between the tie...

    Isn't there a compatibility issue between the tie rods, so you would need the rack with rods and ends, rather than using the s15 rods on the s14 rack. I could be talking out my arse.
  2. Thread: Aftermaket Tacho

    by TomK
    Replies
    12
    Views
    769

    Thanks guys, that's given me some homebrew things...

    Thanks guys, that's given me some homebrew things to try, if they don't work i will have to order the autometer adapter in from America.

    I will avoid skyshacks ideas as they are way above my level...
  3. Thread: Aftermaket Tacho

    by TomK
    Replies
    12
    Views
    769

    So... it's impossible to have an aftermarket...

    So... it's impossible to have an aftermarket tacho work on a ca18det if it no longer has the original s13 dials? I know there are some guys who have put the engine into kit cars and older vehicles,...
  4. Thread: Aftermaket Tacho

    by TomK
    Replies
    12
    Views
    769

    Unfortunately the engine is no longer in an...

    Unfortunately the engine is no longer in an S-body so there are no original clocks in there to take a feed off of. I guess that's why i'm having so much trouble.
  5. Thread: Aftermaket Tacho

    by TomK
    Replies
    12
    Views
    769

    Thanks for the suggestion. I went and tried this...

    Thanks for the suggestion. I went and tried this today, but to no avail, so i tried on the ground of the power transistor, working under the same theory, but no joy.

    I aslo tried putting a 10k...
  6. Thread: Aftermaket Tacho

    by TomK
    Replies
    12
    Views
    769

    It might not be as low as a quarter but, its...

    It might not be as low as a quarter but, its definitely between that and half.

    I connected it up to the tacho output from the ecu today, but that didnt even make the gauge move, so i guess it's...
  7. Thread: Aftermaket Tacho

    by TomK
    Replies
    12
    Views
    769

    Aftermaket Tacho

    Hi,
    I've bought an aftermarket tacho and am having difficulty connecting it up. It says you can wire it up off of the coil/distributor or the power transistor. I've attempted to wire it up off of...
  8. Replies
    189
    Views
    122,426

    Where did you get the rear axle setup from, if...

    Where did you get the rear axle setup from, if you don't mind me asking.

    Is it a kit specifically for the Amazon or is it a generic kit that will have to be modified to fit?

    I'm in two minds as...
  9. Replies
    11
    Views
    15,629

    I use DAL, top bloke, he stuck my CA18det into my...

    I use DAL, top bloke, he stuck my CA18det into my volvo 240 for me.
  10. Replies
    189
    Views
    122,426

    Think i saw your engine when i was picking up my...

    Think i saw your engine when i was picking up my volvo. Am looking forward to seeing this project, should be immense.
  11. Replies
    16
    Views
    2,340

    Rear wheel steering was available on a load of...

    Rear wheel steering was available on a load of the japanese coupes in the 90's, then seemed to disappear, and is now making a resurgence.
  12. Replies
    6
    Views
    776

    I have a set of Nismo subframe bushes in my...

    I have a set of Nismo subframe bushes in my garage from when i used to have my s13, Brand new in box, i think these may have been discontinued now. Drop me a PM if you are interested, not the...
  13. Thread: Wheel bearings

    by TomK
    Replies
    6
    Views
    359

    It was a few years ago now that i did the...

    It was a few years ago now that i did the conversion. I know I didn't use my hubs, because i have them in the garage. Maybe I'm getting confused then, I know i bought a complete r33 gtr brake set up,...
  14. Thread: Wheel bearings

    by TomK
    Replies
    6
    Views
    359

    Thanks for the link. Yes, complete rear hub...

    Thanks for the link.

    Yes, complete rear hub from a r33gtr, drum handbrake, gtr calipers etc.
  15. Thread: Wheel bearings

    by TomK
    Replies
    6
    Views
    359

    Wheel bearings

    Hi,
    The rear passenger wheel bearing on my s15 needs replacing, fast, but i've swapped out my rear hubs to those off of a R33 GTR when i did my rear brake conversion. Are the wheel bearings the same...
  16. Replies
    491
    Views
    72,665

    I think you made the right call with the bonnet...

    I think you made the right call with the bonnet spacers.
  17. Replies
    71
    Views
    2,719

    I've heard a lot of good things about GFB...

    I've heard a lot of good things about GFB (admittedly mostly from MCM)

    I've gone with an SSQV, dumping to atmosphere because i still like the childish noise, but i've mounted mine in the less than...
  18. Replies
    47
    Views
    21,323

    Hell of a thread revival. Becuase the post is...

    Hell of a thread revival.

    Becuase the post is 13 years old, and are no longer hosted on the site he used (edit: sxoc as it turns out [edit2: nope suicide squad.com most be an old hosting site]),...
  19. Replies
    22
    Views
    1,448

    I have read very good things about these people...

    I have read very good things about these people http://www.bernardnewbury.co.uk/ Always intended to take my seats down there to get a quote, but something always seemed to rear its ugly head (blown...
  20. Thread: Project Phoenix

    by TomK
    Replies
    964
    Views
    255,151

    Love your dedication, after 4 blocks and that...

    Love your dedication, after 4 blocks and that last total engine failure, you still don't give up. :thumbs:
  21. Replies
    4
    Views
    627

    If you find the code, and get a price from...

    If you find the code, and get a price from nissan, put the information up here, i would be interested to know and im sure a few others would be too.
  22. Thread: gauges

    by TomK
    Replies
    1
    Views
    416

    I removed all the climate controls and the stereo...

    I removed all the climate controls and the stereo in order to get the wires up the back and to hold them in, as the gauges were a tight fit anyway, I just used three blobs of silicone on each one,...
  23. Thread: S15 windscreen

    by TomK
    Replies
    6
    Views
    980

    I think Garage D had some made, im pretty sure it...

    I think Garage D had some made, im pretty sure it was them.
  24. Replies
    20
    Views
    1,280

    When i did it i was able to pick up a set of r33...

    When i did it i was able to pick up a set of r33 gtr rear hubs along with the whole rear brake assembly. It made the change over a very simple job.

    Also fitted r33gtr fronts along with BMC and...
  25. Quick question regarding parts for engine rebuild

    I'm a bit out of touch with who to buy parts from these days.
    Can anyone recommend where to buy things like ACL big ends and mains, cosworth head gaskets and wiseco forged pitons for an sr20?
    ...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4