I'm getting some rear over fenders for my s15
Is it best to use rivnuts or bond them on
I want the car to look good but still want to drift it
What do people think
Sent from my iPhone...
Type: Posts; User: jakertaylor
I'm getting some rear over fenders for my s15
Is it best to use rivnuts or bond them on
I want the car to look good but still want to drift it
What do people think
Sent from my iPhone...
I should be there in the s15
Sent from my iPhone using Tapatalk
I'm up for it car should be ready by then all mapped and caged
Put me down for any at the mo
Sent from my iPhone using Tapatalk
Want to get my s15 roll caged to full bdc spec how much do people think it will cost, how long will it take and where is good to do thanks
Sent from my iPhone using Tapatalk
I missed it in end as well went to the beach lol
Sent from my iPhone using Tapatalk
I'll be there think me and Barry will meet u and morrisons
Also dose any know if the monthly reading meet still happens and is it to night
Sent from my iPhone using Tapatalk
Any one know if the monthly reading meet is still on and what time it start
Sent from my iPhone using Tapatalk
Found it was a split in one of the silicon joins haha thanks for your help tho
Sent from my iPhone using Tapatalk
So I was driving my s15 rb25 for the the first time to day since the conversation
Drove it from Portsmouth back to basingstoke then round basingstoke for a bit so about an hour and a half work of...
Have got a hkb boss now and found that nrg do a short snap off boss so have sent back my low standards snap off and got the hkb and thin snap off from nrg
And still get to keep my horn and Ari...
Just been told that you can't get a short hub for the s15
Sent from my iPhone using Tapatalk
Yer had a look at works bit out my rang haga ok cool will take a look at funky power
Got my grip royal from wheel power
Sent from my iPhone using Tapatalk
I'm looking for a steering boss for my s15 iv already ordered a grip royal wheel and horn button as well as a low standards snap off boss
But I'm looking for a short boss that will fit the s15...
Yer I asked for the compression test results from them after and they said they couldn't find them on there system but sure they where good
So still say it was something I did even if the car has...
I will have to let you know as I'm still trying to do the rb swap on my s15
( jdm ****ed me over with the rb25 they sent me they sent me one with a blown head gasket and are now not taking any...
Any body know how to get and s15 speedo to run with and rb25 engine, gearbox and loom
As I know the s15 runs off abs and I don't have abs or the s15 loom
Sent from my iPhone using Tapatalk
Hey I need a bit of help adapt getting my s15 dash loom to fit my rb25 det loom mostly the f4 pin...
Bump
Sent from my iPhone using Tapatalk
Also need the rb25 from an r33 f4 pin lay out as the s15 and r33 only 2 pins line up
Sent from my iPhone using Tapatalk
Mostly need the f4 plug
Sent from my iPhone using Tapatalk
I need a Nissan s15 spec r wiring loom diagram asap like now asap so I can finish of my car ????
Sent from my iPhone using Tapatalk
Has any one got a guide for the wiring from sr20 to rb25 on a Nissan s15 ???
Sent from my iPhone using Tapatalk
Any one know what wires need to be saved or where the disconnected the sr20 lol to get the rb25 one in ???
Sent from my iPhone using Tapatalk
Are s15 and s15 brake discs the same size on standard calipers
Looking at getting some grooved discs for my s15
Sent from my iPhone using Tapatalk
Think I'm just going put the rb as a stock rb with my intercooler a better rad and clutch a front facing intake then build on the power from there with a bigger turbo and all the bits to go with it...