PDA

View Full Version : Strut Brace.


S12Kelv
27-09-2003, 20:08
Would a strut brace suitable for the S13 fit the S12?

It appears it would, anyone tried this, or have a definite answer?


Thanks.
wacomuk
23-10-2003, 10:03
i have a strut brace what i made for my silvia i will take it up to pauls ans try it on his s13 if it fits were laughing :)
Ned
23-10-2003, 10:45
Did Paul make his own? They looked nice
wacomuk
23-10-2003, 12:08
yes he did all 3
silviagod
25-10-2003, 20:58
:wave: Did I hear someone talkin about me! I'll measure em tomorrow and let you know. Remind me wacomuk if I forget :D
wacomuk
25-10-2003, 23:22
ocallydocally
S12Kelv
26-10-2003, 17:53
And the result was?
wacomuk
26-10-2003, 20:16
did not do it to busy scraping my old s12
S12Kelv
26-10-2003, 20:47
OK. Thats allowed :D
SteveCarter200
29-10-2003, 23:04
I tried it today, whipped my Cusco one off my S13 and............
















......... it doesnt fit.:(

The end plates will go on fine, the PCD is the same but the bar is about 3" too long and sits far too high. Plenty of room over the engine but the bonnet wont shut.
wacomuk
29-10-2003, 23:08
does it fit the stud patten or not ?? was it to long ??
SteveCarter200
29-10-2003, 23:16
Originally posted by wacomuk
does it fit the stud patten or not ?? was it to long ??

Err, yes and yes.


Originally posted by SteveCarter200

The end plates will go on fine, the PCD is the same but the bar is about 3" too long and sits far too high. Plenty of room over the engine but the bonnet wont shut.
wacomuk
29-10-2003, 23:19
ups missed that bit
SteveCarter200
29-10-2003, 23:22
Originally posted by wacomuk
ups missed that bit

Thought so.:D:smash:
S12Kelv
30-10-2003, 01:58
Local Engineering firm a visit then...
or buy some metal and learn to weld..
wacomuk
30-10-2003, 07:49
learn to weld it will come in handy!!