PDA

View Full Version : h-dev lambda wires


royellison
31-03-2010, 09:24
Hello there,
Had a slight mishap with the lambda sensor plug melting on my manfold so i cut the plug off.
On your lambda its got 2 black wires and one blue.

My lambda loom is a blue wire,black wire with a yelow one inside,and a brown wirf.
Wich goes to what?
Thanks
Jez
31-03-2010, 15:04
I'm not sure to be honest - best to have a look at the service manual. The back wires are for the heater, white is the signal.
royellison
31-03-2010, 15:18
ok, well what is the blue wire for in your lambda sensor? what does that connect to?
royellison
31-03-2010, 19:51
wired it up,..ran a tad worse.. going to have to bring it in to you lot i think.

had enough now.

are you open over this weekend?
Jez
31-03-2010, 19:53
ok, well what is the blue wire for in your lambda sensor? what does that connect to?

My memory fails me - I thought there were just 2 black and 1 white. I'll check tomorrow

If you'd like to come over, thats cool but I'm afraid we're not open weekends.
royellison
31-03-2010, 20:08
How much roughly to get my car on a rolling road and set the boost up,check 4 det and have a basic look at it?
Jez
31-03-2010, 20:36
Best to set the boost up on the road to be honest - we can do this, check for det and check the fuelling for £49.99
royellison
31-03-2010, 20:50
I Have ditched my heater matrix because it was leaking,could this be causing det? or my greddy race plugs?
royellison
31-03-2010, 20:54
Ditching the heater matrix is making it run hotter i mean causing det.
Jez
31-03-2010, 20:57
Ditching the heater matrix shouldn't make it run hot. Sounds like you've got a cooling problem if its getting too hot.

If it is getting too hot then it can make detonation more likely.
royellison
31-03-2010, 21:02
Shot in the dark but would taking the thermostat out alowing the water to circulate quicker cool it much more?
Jez
31-03-2010, 21:14
It might, but the point is you shouldn't have to do that. I'd imagine you could have a clogged radiator or poor air flow through it.
royellison
31-03-2010, 21:55
Changed the plugs to my usual ones,idle is smoother and i fink the det has gone,sure i heard a lil bit in 3rd ful boost,smels realy hot under the bonet.
Jez
08-04-2010, 22:16
Hope thats sorted it for you :)