will i have problems

[Amxen]

OKs my turbo went 2 weeks ago so i'v gone out n got my self a nice new
gt28r, a SS manifold, some nice new braided lines, some new gaskets all good :thumbs: Iv already fit a turbo back decat 2 1/2" exhaust ( i think it was 2 1/2") , a huge FMIC an apixe filter. Now i dont have as yet any typ of boost controller so my question is am i gonna have any issues running on stock boost ?
any opinions

black top sr20det 180sx

[Amxen]

no one

[sss_sx]

Is it an SR or CA engine?
Have you got any type of chip?

[T.J]

at the bottom of the thread it says 'black top sr20det 180sx'

[John Bennett]

My 180 blacktop ran ok on actuator pressure boost with a T28 and a bog-standard ECU.

[STR8E180]

it will run but ur wont be making the most of ur mods untill u have ur ecu tuned to suit
u should also look at upgrading the fuel system to suit the turbo to make the most of it

[sss_sx]

at the bottom of the thread it says 'black top sr20det 180sx'


DOH!!! :annoyed:

[Amxen]

it will run but ur wont be making the most of ur mods untill u have ur ecu tuned to suit
u should also look at upgrading the fuel system to suit the turbo to make the most of it

ok cool i know it needs the ecu sorting to get the best from it . im just making sure its not gonna lean out or over fuel to much.

next on the list clutch , fuel pump, boost controler, and ecu sortin. its never ending this datsun lark

[jod]

i had a similar spec a couple of years ago and mine ran fine with the standard ecu.

[STR8E180]

ok cool i know it needs the ecu sorting to get the best from it . im just making sure its not gonna lean out or over fuel to much.

next on the list clutch , fuel pump, boost controler, and ecu sortin. its never ending this datsun lark


unless ur changing injectors it shouldnt over fuel
it might lean out because the injectors cant push out enuff fuel to even out the mixture ratio so i wouldnt go boosting it at stupid levels untill u have sorted out ur fuel system and ecu