T3 turbo and maifold setup?

[ninhjas]

Hi to all!

Has any one here have done the above?
Could I have some info and picture of how it look?

[norfy]

i have a top mount manifold with a t3 flange on it if that helps? the turbo im using is a holset hx35 super.

http://i578.photobucket.com/albums/ss223/norfydori/2009/DSC03423.jpg

[ninhjas]

Do the turbo used oil only right?
Have you got any more picture?

[norfy]

im currently fitting it to the engine, have plenty of pics. not quite tackled the oil feed/return system but they are not going to be the hardest thing to do.

[ninhjas]

Need a bit of info on the oil in/out braded oil pipe and adaptor fixing.

[xR33]

Best thing to do is contact Hose Solutions and get them to make you one up. I think 2ft is about the right length, and most T3s have a thread on the oil inlet, so you may not need an inlet adaptor flange. You can buy a flange for the oil outlet and use rubber oil hose to connect it to the sump, or try and adapt the one from the T28 and use some new hose.

[ninhjas]

Thank, for the info.
I do need to get it sorted.

[xR33]

No problem. I test fitted my Topmount on my CA S13 and found that I'd have to remove the ABS - You may find you have similar problems.....

[ninhjas]

My is a 180sx, with no abs.

[ninhjas]

Need help with wich vac pipe goes where?
T3/T4 top mount turbo. with external waste gate.