Long Briaded Brake Hoses, and...

[Rich_M]

Hi Dan,

1)Can you get braided front hoses that replace both the standard rubber hose as well as the short metal pipe that goes into the calliper on the 14a?
IIRC that dano used to do them.

2)Do you have recomendations on what spec brake fluid to use with your M3 315mm kit, fast road driving covers less than 4k a year.

3)Can you offer any other pads for the 315mm kit, i currently run standard size ebc redstuffs but i don't like them. Can you get the reworked pads in something good like ds's or project Mu streets?

Thanks

[Dan@DB-Power]

Hi Rich

1:) Yes chap all my braided hoses do this :) Price is £30 + postage :)

2:) Personally any dot 5.1. would be fine :)

3:) I can only get reworked DS2500's, DS3000's, Redstuffs and Yellowstuffs.

Dan :thumbs:

[Rich_M]

Sorry for delay, i have been away on my holidays.

Good job on the fronts, i will be ordering soon.
How much for the reworked ds2500's? (s14 caliper with 315mm M3 kit)
I have already run the standard size red stuffs on the 315mm brembo discs, is it ok to switch straight over to the big pads or will the rusty surface need to be cleaned up a bit first? (covered about 2000 miles on them?)

Thanks,
Rich.

[Dan@DB-Power]

Hi Rich

The reworked DS2500's are £142. As for cleaning up the disc, maybe a little just to get the worst off :)

Dan :thumbs:

[Rich_M]

How much for the front and rear braided hoses together dan, if im bleeding the system for the fluid change i may as well do the rears as well.

[Rich_M]

How much for the long front hoses and the rears as well (full set) do they come with all washers and fitting to bolt straight on?

[Rich_M]

bump.

[Dan@DB-Power]

HI Rich

Sorry for the delay, front and rear hoses would be £60 + £5 delivery :)

Dan :thumbs:

[Rich_M]

Sorry to drag this thread up again - can you confirm what size of fitting/union is required to screw directly into the s14 calliper?
Is it an M10 x 1mm thread (like the one on the mastercylinder)?
Thanks,
Rich.

[Dan@DB-Power]

Yep :)