PDA

View Full Version : Angle grinder?


dj_C
27-01-2006, 21:13
Anyone near Swindon got an angle grinder I could borrow for the weekend? Fitting my FMIC tomorrow, and am a little concerned about taking either a hacksaw or a lump hammer to my chassis legs....

There's beer in it if someone has one lying around? :thumbs:
dj_C
28-01-2006, 20:45
Not to worry - managed to buy one for £15 in the end...
Aitch
28-01-2006, 20:47
If I'd have spotted this earlier, I'd have sent you mine and insisted you keep the fcuker - I ended up in casualty last time I used it :annoyed:
dj_C
28-01-2006, 21:00
lol, not to worry mate. Was the funnest bit of doing my FMIC today...

http://img.photobucket.com/albums/v331/djc42/Car/IMG_0773.jpg
Dave_S14
08-02-2006, 18:45
Only just seen this, You got it fitted no problem then mate, you should have pm'd me, I have one with a nice new diamond tipped bit on it, did you have to buy the hole saw aswell? Any problems fitting it, and wot did you do about the battery?

Dave.
dj_C
08-02-2006, 21:09
Yeah, all sorted no worries. Bren sent me a hole saw with the cooler, and I fitted a race battery, so it's all good. Got other worries with the car at the moment, but the cooler is sweet.

Seem to have lost a lot of oil today, so it was running like a dog. Chucked a litre of cheap shit in it, just to get home from Southampton, but need the garage to take a look at it. VVT rattle seems MUCH worse too, and is doing it when driving around, not just when pulling away. :indiff:
dj_C
10-02-2006, 20:04
Turned out that my turbo oil seals are gone, meaning the oil was all burning off.... hence the rattle.

So, it's new turbo time... :smash:
MeLLoN Stu
10-02-2006, 20:05
If I'd have spotted this earlier, I'd have sent you mine and insisted you keep the fcuker - I ended up in casualty last time I used it :annoyed:

were you surprised by this? :confused: :D